|
We announce the availability of a firmware upgrade patch for Play@TV™ NMP-4000 Ver. 1.7 Patch (19 Feb 2004).
After downloading, it is recommended that you read following information first before using the program.
This patch file is for only Play@TV NMP-4000. In case of updating this patch to NMP-1000/TGNMP-3000(in Korea) or PC-MP1000(in Japan), it cause critical damage to Play@TV. You are supposed to check your model name first.
[Improvements]
 Fixed the bug that sometimes the 'Network not smooth' error message is displayed even when the network status is very good.
Fixed the bug that MPEG2 files with peculiar characteristic (big pack size) cause media playback error when played in Direct Transmit mode.
Fixed the bug that 5.1ch audio is not output for DivX file with AC3 audio when some model of Yamaha AV receiver is used.
[Install Patch Program]
1) Download the patch on this page to your PC.
2) Before executing the program, verify that your Play@TV™ and PC are connected after turning on Play@TV™.
3) This patch program is an auto-run program. It will run automatically after unzipping.
|
* The patch program will not run in the following cases and an error massage will be displayed on the screen instead.
- If Play@TV™ is not installed.
- If the installed Play@TV™ is not the correct version.
|
[Firmware Upgrade]
1) The following massage will be displayed when the patch is installed completely. After clicking the [OK] button and pressing the power button of the remote controller to turn off Play@TV™, turn on Play@TV™ again.
2) If the Play@TV™ works again, save the new version of the firmware in flash memory after downloading it from your PC.
It will take about 1 minute to upgrade the firmware. Don't turn off Play@TV™ during the upgrade. Once the upgrade is completed, Play@TV™ automatically works again.
|
